New FlowArm V2
Here are the release notes:
You can now control two arms from the same SC-32. To do this just open a second instance of the FlowArm software. The second program will automatically become the Arm2 controller and talk to the Arm1 application (requires Networking & UDP port 80). You can even run the Arm2 software on another PC on the Network!
You can now use the onscreen switches to control the SC-32 output pins 8-15 (Arm1) & 24-31(Arm2).
There is now a pause sequence slider to allow pauses of up to 1min (60000ms) between sequence steps.
The Spare Servos A & B now work properly.
The Servo Speed slider has been reversed as requested.
New screen sizing buttons have been added S = Small, M = Medium, & L = Large + there is a Full Screen toggle and a Quit button.
The software and source code can be downloaded by official FlowStone users from here:
http://www.dsprobotics.com/support/viewtopic.php?f=36&t=189
No comments:
Post a Comment